The Cantek MX330 Automatic Edgebander is a compact entry-level edgebander with the perfect blend of quality and affordability. With fine attention to detail and quality componentry, the MX330 can output high-quality edges on cabinet parts and more. The machine is equipped with end trimming, flush trimming, and buffing units. User-friendly controls and adjustments allow for efficient changeovers of edge tape thicknesses between 0.4mm & 2mm.
- Compact design makes it the ideal edgebanding solution for small workshops.
- Precise adjustments for optimum edge quality.
- Castor wheel adding mobility to your edge bander.
- Available in 230V, 1-Phase.
A. Heated Infeed Fence
The infeed fence is heated which pre-heats the panel prior to the glue being applied. This results in deeper penetration of the glue inside the panel allowing for optimal conditions for the best bond. The temperature is adjustable to your specific requirements.
B. Glue Spindle
The steel serrated glue spindle ensures optimal glue coverage on the edge of the panel. The glue amount can be conveniently adjusted using an adjustment knob.
C. Guillotine Shear
The guillotine shear can trim coiled material up to 2mm in thickness. This can be turned off for individual strip feeding
D. Pressure Rollers
The pressure roller unit consists of one large chrome steel roller and a smaller chrome pressure roller. The pressure rollers ensure the edge is properly adhered to the panel edge the glue bond between the edge. The rollers are adjustable to the edge thickness by referencing from a sample of the edge. This ensures consistent pressure for optimum bonding results.
E. End Trimming Unit
The end trim saw unit is mounted on high-precision linear bearings, which ensure perfect cutting results. The high RPM dual saw blades meet any challenge, regardless of edge type & thickness. The blades trace the leading and tail edge of the panel to ensure the exact precision of end cuts. The sawblade turn at 8800 RPM. (2) Blades are 80mm in diameter.
F. Flush and Radius Trimming Unit / Top and Bottom Trimming Unit
The top and bottom trimmers are spring-loaded and use a tracing wheel to trace the panel's surface. The result is a consistent trimming of the edge according to the panel surface. The rollers also ensure no marking of the workpiece. The knives are capable of flush and radius scraping with 2mm radius knives as standard. They can be adjusted in and out using mechanical digital readouts for repeatable and accurate positioning. The insert knife cutters turn at 10500 RPM.
G. Buffing Unit
The buffing unit leaves a super finish on ABS and PVC edging and removes any discoloration on the edges, especially when working with dark edge material.
